Installation Guide for Ink Head of Garment Digital Direct Jet T-Shirt Printing Machine

by:angelacrox     2021-09-01
If a T-shirt printing machine manufacturer changes it, you have to wait a day or two. In this way, the digital direct-injection garment printing machine has to be stopped, and the production has to be stopped. This is a big deal for the digital printing factory. The small loss, coupled with the back and forth costs of the T-shirt printing machine manufacturer after the sale, is even more not worth the loss, so doing it yourself is the kingly way. So, once the ink head of the garment digital direct-injection T-shirt printing machine is damaged, we need to replace it with a new one. Let’s take a look at how to correctly replace the ink head of the digital direct-injection garment printing machine!   The ink head replacement of the digital direct-injection T-shirt printing machine is not particularly complicated. It only takes a few simple steps. As follows:    1. Before installing the ink head, first make sure that the machine is in normal motion, the ground wire of the digital direct-injection garment printing machine is well connected, the voltage on the trolley board is normal, and the voltage of the ink head power supply is normal. ! The easiest way is to use a multimeter to measure whether there is static electricity on the machine, the voltage of the trolley plate, and the power supply voltage of the ink head, and then disconnect the ink head power supply.   2. Pick up the ink head of the new clothing digital direct-injection T-shirt printing machine, first uncover the air hole seal (that is, the label or sticker attached to the nozzle), pour 70-80 water or alcohol, and soak! 3. Then place the ink head of the digital direct-injection T-shirt printing machine with the nozzle facing down on the paper towel and drip the ink for about 2 to 5 minutes, until the ink completely penetrates the paper towel, and then connect the ink head to the ink needle and touch the ink head. Point upwards and use the ink absorber to slowly absorb the air in the pipe, then rotate the ink head 180 degrees and use the ink absorber to slowly absorb a small amount of ink, and finally wipe the contacts and nozzles with a paper towel to perform the work on the machine. 4. Finally, after installing the ink head, we will first clean the print head for the new ink head. Generally, it is best to clean the ink head 3-5 times. Please clean the ink head at least once; once the new ink head is installed, one -Do not touch the surface of the ink head with your hands, and do not remove it at will.   If you want to better maintain the ink head of the garment digital direct-injection T-shirt printing machine, you must understand how to install it. This will help us maintain it better in normal times.
Custom message
Chat Online
Chat Online
Chat Online inputting...