Modified nozzle of digital direct injection machine
In the later stage, the customer of the digital direct injection machine found that the production capacity of the machine could not meet the demand. When they did not have enough money to buy a new machine, they had no choice but to modify the nozzle. So what should be changed and what needs to be paid attention to when refitting the nozzle of the digital direct injection machine? Let’s first talk about what needs to be changed for the digital direct-injection conversion nozzle? 1. The motherboards of digital direct inkjet printers with different models and configurations of boards are different. Naturally, if you change the print head, you must first change the board. 2. The ink circuit board is changed, the nozzle is changed, and the ink circuit of the corresponding digital direct-injection machine has to be changed accordingly. 3. Different types of nozzles and different numbers of nozzles on the nozzle bottom plate use different nozzle bottom plates. Since the nozzles have been changed, the nozzle bottom plate must be replaced. 4. Cleaning stack The cleaning stack is used in conjunction with the nozzle bottom plate, otherwise it cannot be cleaned or moisturized. Since the nozzle bottom plate has been replaced, the corresponding cleaning stack must be replaced. After finishing the above modification, then the software will re-make the corresponding settings, and the work of modifying the nozzle of the digital direct injection machine will be completed. So what should I pay attention to when refitting the nozzle of the digital direct injection machine? 1. The modification plan should match the model. Relatively speaking, the modification potential of a small digital direct injection machine is relatively small, while the modification potential of a large digital direct injection machine is relatively large. Or the 8-sprinkler plan can be done or not, but after the change, most of the time is wasted on manual operation in actual use, the efficiency is not high, and the operator is very tired, but the large-scale Digital direct injection machine modification potential is greater. 2. You must choose a mature solution. If you want to change the nozzle of the digital direct inkjet printer, you must first investigate. This nozzle is a more mature solution, such as Epson 4720. At present, the more mature solution is the 4-jet solution, but you have to If you need 8 nozzles, it is so good and you can do it, but after the modification, its efficiency and effect are incomparable with the 4 nozzles, so you must choose a mature solution, and don't go too far to be a guinea pig.